FAKE CAR ALARM LED LIGHT- RED AND BLUE ALTERNATING

Description

AUTO THEFT DETERRENT LIGHT ( FAKE CAR ALARM )
Color: RED AND BLUE ALTERNATING COLORS, changes from Red to Blue around 100 times per minute.
Brand New!
Ultra Bright device, designed for 12 & 24 volt applications, alternates from red to blue in less than a second (around 100 times per minute). This vehicle theft deterrent light product can protect your property from potential thieves, especially at night. The bright flashing LED light simulates the lights used in expensive vehicle alarm systems, causes thieves to pass your vehicle in search of an easier target. The light can also discourage break-ins in daytime. Easy to install and looks clean on your dash panel.
The LED light will flash when your ignition is turned off and will not flash when you have your ignition switch on. This LED alarm does Not require a car alarm system. MADE IN USA.
Details:
* 1 pc 5mm Red and Blue alternating color LED fake car alarm device
* 1 LED retainer. Retains the blinking LED and is a nice clean trim bezel
* 24 inches of power wire. Should be long enough for most installations
* Input voltage: 9~24 Vdc.
* Can be mounted to metal or plastic
* Looks good on dash panels. Does not look like a cheap chrome "Add on"
* Small compact size
* 12 year + life span
* Car, Boat, Motorcycle, RV, ATV
* low power consumption. less than 20mA when blinking
* Yery bright ! Luminous intensity: 5,000 mcd
* Simple install instructions included
* Made in USA
We can also supply 6 volt fake car alarm lights. Just ask!
Do you want other colors or types?....See our store, or e-mail inquiries!
Discounted shipping:
Use the cart tab.
LED mounting retainer information:
* Included with LED light
* To retain LED to your dash or panel
* Color: Black Nylon
* Panel cutout hole (hole diameter in you panel) =  1/4"
* Panel thickness:  0.050" ~ 0.100"
* Outer most diameter of retainer:  0.307"
Colors available:
Yellow, Red, White, Orange, Blue, Green, RGB, Dual color, Others. (see listings)
Simple Installation:
1,  Locate a good place to mount your flashing LED,  make sure you have access to the back    to run wires.
2,  Drill a 1/4 inch hole for the LED retainer bezel.
3,  Snap the LED retainer bezel into hole.
4,  Push the LED flashing light into the back side of LED retainer to lock in place.
Simple two wire connection:
1,  Connect RED wire to fuse block that has 12 volts when vehicle is
running or not
(Hot at all times)
2,  Connect YELLOW wire to fuse block that has 12 volts
only when vehicle is running
(Hot when running only)
Made in USA